Hey guys, got a question. And I should probably know the answer to this. What I want to know is, can I completely remove the skid plate on my 300 KQ, (2000) model..? I know you can remove the front portion of the plate. But I'm just wondering if you can remove the whole thing. I'm assuming yes based on if you get a new frame I believe you can just swap it over. Dumb question I know. Just not thinking straight since I'm kinda pissed right now. Just found small puddles of oil under my atv, and I'm not sure where it's coming from. But the locations of the puddles seem to indicate it's coming from the middle of the bike someplace. Yet I can't visually tell. I'm going to look further into it probably Wednesday if I can find the time. But I'll probably have to pull the plate to see where it actually coming from.
ajl719
Joined
·
1,489 Posts
Yeah it's held on with a bunch of 10mm bolts. Be warned if you're asking the question safe to assume it hasn't been off before and they will almost all break off. Good Luck AJ.
Also the oil could be from somewhere easy like the drain plug or anywhere really, it will drip then run across the skidplate and drip out the holes so it may not be immediately above the drip on the floor.
Also the oil could be from somewhere easy like the drain plug or anywhere really, it will drip then run across the skidplate and drip out the holes so it may not be immediately above the drip on the floor.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
