Hey guys, got a question. And I should probably know the answer to this. What I want to know is, can I completely remove the skid plate on my 300 KQ, (2000) model..? I know you can remove the front portion of the plate. But I'm just wondering if you can remove the whole thing. I'm assuming yes based on if you get a new frame I believe you can just swap it over. Dumb question I know. Just not thinking straight since I'm kinda pissed right now. Just found small puddles of oil under my atv, and I'm not sure where it's coming from. But the locations of the puddles seem to indicate it's coming from the middle of the bike someplace. Yet I can't visually tell. I'm going to look further into it probably Wednesday if I can find the time. But I'll probably have to pull the plate to see where it actually coming from.
ajl719
Joined
·
79 Posts
So the mid and back skid plates are held on with four 10mm bolts each. Should be pretty easy to remove them without any kind of ramps. I've only removed mine once and I didn't break any bolt, but where I live we don't have that much of a problem with rust.
As for the oil leak, try to retighten the drain plug. Otherwise I'm guessing it comes from the engine cover on the pull start side. Mine had a minor leak there.
Good luck!
As for the oil leak, try to retighten the drain plug. Otherwise I'm guessing it comes from the engine cover on the pull start side. Mine had a minor leak there.
Good luck!
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
