Suzuki ATV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
My rear brake cam was frozen when I got my quadrunner. I managed to heat it up and get it out. I ordered a new one with seals but was notified that the cam lever is out of stock at suzuki with no eta. My question is do you think I can clean up my cam and put it back in with a lot of bearing grease or if it was that bad when I got it that its not able to be reused? I had a hard time getting it out and don't want to keep putting it in and out and risk causing more damage to the brake anchor. I have 2 choices, buy a used one off ebay that says it's "in good order" and get it soon or buy a "new" one from Japan and get it in a month and way overpay for it. I don't have a press and I assume I'm going to need one to get it back in. If I had a press I would try it and see how it goes but since I don't I figure getting it in and out could damage more parts just for a hope something might work.
 
1 - 1 of 1 Posts
Top