Suzuki ATV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hello, i bought a quadzilla a few months back that needed work. It ran but compression was low and you had to give it ful throttle to fire up. I had the cylinder bored with a new Weisco top end kit. I have BRAND NEW vforce 3 I installed. I cleaned the carb and it was dirty. When I put the gas on a little bit flows out of the back of the carb.. Just a few drips here and there. I poured a little gas down the cylinder and still had no luck. I have good spark. Any ideas of what is wrong or if I did anything wrong?
 
1 - 1 of 1 Posts
Top