Suzuki ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
278 Posts
Discussion Starter · #1 ·
I got tired of fighting the clutch adjustment on my Quadrunner and Kingquad. So i made a simple tool.

Automotive tire Motor vehicle Hand tool Bicycle part Bumper
Automotive tire Plant Wood Bumper Reptile
Automotive tire Motor vehicle Automotive fuel system Gas Auto part


It's just a cheap Taiwan 12mm socket and some 3/4in Flat bar i had leftover from an earlier project. I cut a piece of the flat bar. Then rounded the end to fit the socket. I ground the chrome off the end of the socket and welded them together. Put it in the vise and bent the handle out a little.

Put the socket on and a Phillips screwdriver goes through the center. So much easier now.
 
1 - 2 of 2 Posts
Top