Suzuki ATV Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 94 quadrunner 250 and have a petcock with a prime option on it. I wanted to switch to a off option petcock and cap the vacuum. The slug inside the tank for the petcock spins so I have to do a tank repair. I started to take it apart and have the 3 bolts off the tank but can not get the tank out of the frame. Has anyone removed the tank before?
 

·
Registered
Joined
·
2,033 Posts
You have to remove the engine.
 

·
Registered
Joined
·
2,033 Posts
Yes ....to remove the tank.
 

·
Administrator
Joined
·
8,986 Posts
I’m not doubting you TC, but is there no other way to change the fuel petcock..? I had mine changed on my 300 several years back by a local Suzuki dealer. And I don’t think they removed the engine whatsoever to change the fuel petcock. I had looked it over after the Suzuki dealer fixed it. And nothing looked like it was as touched engine wise.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #7 ·
It's because the slug inside the tank that the petcock screws into is just spinning. I have to figure a way to unscrew the bolt to remove it.
 

·
Registered
Joined
·
2,033 Posts
AJ....He needs to remove the tank to repair where the petcock screws into.
 

·
Administrator
Joined
·
8,986 Posts
Gotcha. Must of missed that part on my initial read through. My apologies.


Sent from my iPhone using Tapatalk
 
1 - 9 of 9 Posts
Top