Suzuki ATV Forum banner
1 - 4 of 4 Posts

·
Registered
2007 Kign Quad 450
Joined
·
1 Posts
Discussion Starter · #1 ·
I had to replace my battery, typical for KQ 450s, have replaced it many times.
I have the new battery is installed and it appears I have no power to the display and will not even turn over - like the battery is bad? But when winch has lots of power? Any suggestions?
 

·
Registered
2020 KingQuad 750
Joined
·
116 Posts
Check, clean and tighten your battery ground wire at the grounding point. Make sure all your battery connections are tight. Also, you should not have to keep replacing the battery. There must be something on the machine draining it or your charging system isn't working correctly. I'm not very electrical savvy, but someone else will probably chime in.
 

·
Registered
Joined
·
34 Posts
Make sure you attached all the wires at the battery. Even after repeated changes it's not unheard of for a wire to fall down and not get connected.
 

·
Registered
Joined
·
9 Posts
Check the wiring to your key switch….mine was good then overnight it was bad lol (u know how those things go) drove myself crazy chasing my tail replacing everything electrical…..key switch was the last thing I replaced and about $600 later I wish I woulda listened to my buddy who told me to check it
 
1 - 4 of 4 Posts
Top