Suzuki ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Does anyone know if they make a clutch kit for the new model king quad? I am looking for some more low end torque. I was thinking of a clutch kit. But if anyone has any other suggestions. thanks
 

·
Registered
Joined
·
8 Posts
Coop mods with a shim and a yellow secondary spring, not much else available that's not crazy overpriced.
 

·
Registered
2006 King Quad 700. 25" Bighorn originals. Highlifter springs. Twin air. Coop 3+. Dalton clutch kit
Joined
·
51 Posts
The 2019 King already comes with a stiffer secondary spring and light primary weights compared to previous years. My 2006 has Dalton clutch kit which is basically the the same as 2019 model. I would get the shim kit for a few dollars which would lower your gearing about 10%. Basically like dropping one tire size. I have the machined clutch Coop 3+ which gives you 30% lower gearing on the bottom end and tapers out to nothing on the top end. For a couple hundred dollars it was my best mod for sure. And yes if a stiffer spring was needed then EPI yellow would be a good choice
 
1 - 3 of 3 Posts
Top