Suzuki ATV Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello,
I have been blowing the R/H Rear universal joint after replacement with the greasable joints. Only last a couple of miles. Enough is enough. There was some discussion about three /four years ago but I do not see a final outcome or a part number concerning solid sealed joints and the drilled ones. The OEM only wants to sell the entire assemble as you all know$$$$$$$.
Sure hope some one will fill me in.
Bob
 

·
Registered
Joined
·
2,108 Posts
Is it the outside joints in the axle shaft?
 

·
Registered
Joined
·
623 Posts

·
Registered
Joined
·
2,108 Posts
If it is the outside axle joint
POWERTRAIN INDUSTRIES #9951-22 perfect fit...
GMB #220-0045 will work( as Scott mentioned )

The difference in the two are that the Powertrain is .790 diameter
GMB is .787 diameter

See this thread to see pic of the way I installed them...post # 9
http://www.suzukiatvforums.com/foru...king-quad-rear-inner-u-joint-doesn-t-fit.html

These are the parts that WILL work ...made just like the OEM ( outside joint only on your model)

BE SURE to correctly time the u-joints when you put them back in or you will have problems
 

·
Registered
Joined
·
623 Posts
and by timing he means (I had to look it up when I did mine) the inner and outer ujoints are both turned the same direction. check your bearings when you have it apart too because bad bearings will cause your ujoints to wear out faster.
 

·
Registered
Joined
·
2,108 Posts
I can't find any info on the size of the inner u-joint for 94-2000 quadrunner
The ones I listed above will fit the outside
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top