LT80 Clutch Adjusment HELP!!!

cbeery · 11-21-2010, 10:56 PM

I recently replaced the V-Belt on my son's 2001 LT80...Aditionally, replaced a number of parts due to damage/rust including; plate and spring limiter, Movable Drive face rollers (4) and plate, cover, o-rings.

I tried to salvage; Clutch Assembly (cleaning rust off springs, backing plates etc.) the pads didnt look too bad (have been replaced by previous owner as well as modification to taking out 2 rollers from Dr.).

After i put all back together all seemed to be in working order according to manual. However when i tightened the last nut which holds the Clutch housing, Plate and Spring Limiter the rear axle seizes (will not rotate). I loosen the nut and it turns normally.

Torque on this nut is 30-45 lbs. even when not torqued (hand tightened) same results as above mentioned.

Any advice, corrections will be greatly appreciated. Family is hoping to go riding (camping) over the T-Giving Holiday.

Thank you in advance.

Craig

LT80 Clutch Adjusment HELP!!!

how to take to rollers out of suzuki lt80

lt 80 clutch mod

lt 80 clutch mods

lt 80 clutch removal

lt 80 modifications

lt 80 mods

lt 80 rattle

lt80 clutch mod

lt80 clutch mod how to

lt80 clutch mods

lt80 clutch rollers

lt80 clutch torque

lt80 forum

lt80 mods

suzuki 80cc atv

suzuki lt80 belt

suzuki lt80 clutch

suzuki lt80 clutch mods

suzuki lt80 clutch noise

suzuki lt80 forum